Banner Ad 1

1/72 Moebius Skipjack

This is the place to post your submarine build- ups.

1/72 Moebius Skipjack

Postby wlambing » Sun Apr 06, 2014 2:10 pm

Gents,

Intending to use a home-built type cylinder set-up in this beast and was wondering if anyone might share how they did the saddle mounts for their cylinders??? I have some ideas for my build, but figured I'd ask about methods already in use. I know that whatever gets used has to be compatible with styrene adhesives.

Thanks,

Bill
"If you ignore the problem long enough, it will go away. Even flooding stops eventually!"
User avatar
wlambing
SubCommittee Member
 
Posts: 488
Joined: Fri Feb 21, 2003 5:59 pm
Location: Ledyard, CT, USA

Re: 1/72 Moebius Skipjack

Postby Ralph --- SSBN 598 » Sun Apr 06, 2014 10:12 pm

I am currently building this Skipjack and another boat.

I have purchased 1/4" thick by 2.5" wide sheet styrene plastic from McMaster-Carr.
This is the same plastic the Skipjack is made of.
I will be cutting half circles to fit inside the hull halves.
Will be using styrene weld glue.

Also from MCMaster-Carr
I have 3.5" PVC solid rod to make end caps and in cylinder separators.
And I have a 24" piece of polycarbonate tube for my cylinder. Will be cutting that to 21".

I'm using information from another builder, Tim, who has a working boat.
His boat can be seen HERE

I have all the parted needed except the ballast water pump.
3 pumps should be here any day. Only need one.
Ralph --- SSBN 598
Registered User
 
Posts: 85
Joined: Tue Oct 23, 2012 5:11 pm


Return to Builder Threads

Who is online

Users browsing this forum: Yahoo [Bot]