@nandezfj - You need to share with us whether your hull has the stock vacform pressure box installed in it, or if it is in some other configuration..
@Bobthebuilder - I will be watching your build article with interest! I have the same kit, with the torpedo launchers like you do. I see you're using the 2.5 inch Caswell Subdriver. I was thinking about possibly putting that 2.5 Subdriver in my 32P. Will be nice to see the finished result first though. I see no reason why the same Subdriver couldn't be used in both the 32P and the new Bronco 1/35 XXIII models. So that you could swap it back and forth between the two hulls. Though I would prefer to keep the big, 12Volt Pittman direct drive motor setup in my 32p, over the reduction gear drive, with the weaker and cheaper motor used in the Subdriver. I like those big, heavy, solidly built Pittmans..
My 32P still currently has the stock pressure box bonded into the hull with that super strong, never separating "Versilok" stuff. I read that Simon originally did NOT bond those boxes in the hull before shipping the kits out, but too many of the kit recipients did a lousy job at bonding the boxes together and bonding them into the hull, so that the boxes came apart in the water and sank the boat. Too many of those incidents made him bond the boxes together and inside the hull, at 32P, before they were shipped out to customers. Unfortunately, it makes it quite difficult to extract the box if one wishes to do so.. I don't see how you can extract the whole box.. Looks like you left part of it still in there, at least on the one side of the hull where it was bonded with the Versilok. The Versilok bond is along the bottom and on one side of the box in my boat..