I have hooked up my t max and motors to the cilinders and am having a problem, using K5 to test hooks to my receiver and it is a 3 position switch, using a regular servo to test in the I position servo is on 1 side, switching to 2 position it it goes to middle and 3 goes to other side.Then I removed the servo from the test When I put power to the tmax I here a relay pull in and the piston on both sides pull the piston all the way in and then it pushes out and stops. I tried moving the 3 position switch and nothing happens. I have the poitioners hooked to the tmax but do not have the them hooked to the receiver yet, also I do not have the pleasure switch hooked up yet. I followed the wiring diagram to the tea and triple checked my work what is going wrong? Could it be that I do not have K6 &K7 hooked to the receiver. any Ideas. I am stopping right now to I here from you I don’t want to break anything, but funny thing is when I turn power it cycles every time, but wont work after that.