I was going to build new yokes at first but then thought about it and said I will build it as is first and see.
The yokes are so nice that it would be a shame not to use them.
My hull is off a bit where yours is as well.
Not as much, but once the turtle deck is on it is not noticeable.
I think once it is black unless you really look for it you would not tell.
I think anything I would do to make it better would screw up the good scribing and look like crapola in the end.
It is hard and I am sure the front and rear sections are not molded as one part.
This could easily cause them to be a little off.
I did not bond my rear turtle deck all around the edge either. I just tacked it to the upper bulkhead and two places in the rear.
This makes it look like there is a separation line like the real boat.
I am having a problem with the piston tank causing RF glitching. It is the metel gears I am sure.
I am going to try an SL-8 R/X as it has fixed glitching for me in the past. BD.