Banner Ad 1

SES II

R/C Submarine modelers

SES II

Postby Kerry Addington » Mon May 24, 2010 3:05 pm

Does anyone still have a copy of the instructions for the ole reliable Subtech SES II ?
Can anyone tell me if I can use it with a 12V pump that draws 1.9 amp max ?
Thanks,
Kerry
Kerry Addington
Registered User
 
Posts: 87
Joined: Fri Nov 11, 2005 1:47 pm
Location: Indiana

Re: SES II

Postby greenman407 » Mon May 24, 2010 3:07 pm

I will check tonight and see what literature that I have left over from the Subtek Albacore.
There are OLD pilots and there are BOLD pilots but there are very few OLD BOLD pilots. MAG
User avatar
greenman407
Registered User
 
Posts: 1188
Joined: Sun Sep 23, 2007 11:11 am
Location: clearwater, florida

Re: SES II

Postby Skip Asay » Mon May 24, 2010 9:53 pm

You should have no problem pulling that much current through the SES-II. That uses the same mosfet as the ST-10 ESC and that could handle 8 amps continuously - without a heat sink.

Unfortunately, I don't have the instructions file any longer.

Skip Asay
The U.S. of A - Land of the Free BECAUSE of the Brave
Skip Asay
Registered User
 
Posts: 255
Joined: Fri Feb 21, 2003 11:04 pm
Location: Sanford, NC

Re: SES II

Postby TMSmalley » Tue May 25, 2010 7:29 am

Like so?

Image
Tim Smalley
User avatar
TMSmalley
SubCommittee Member
 
Posts: 2487
Joined: Fri Feb 21, 2003 8:58 am
Location: Edina, Minnesota USA

Re: SES II

Postby Kerry Addington » Tue May 25, 2010 8:09 am

What service! Skip has informed me the MOSFET can easily handle the pump amp load so we're good to go.
Thanks to all,
Kerry
Kerry Addington
Registered User
 
Posts: 87
Joined: Fri Nov 11, 2005 1:47 pm
Location: Indiana

Re: SES II

Postby Pirate » Fri May 28, 2010 11:38 am

Kerry,
That's what I've been running mine with (12V) since I began with my Seawolf. Now it's on my Ohio (12V) too, and working just fine.

Pete
HOLD FAST
User avatar
Pirate
SubCommittee Member
 
Posts: 799
Joined: Wed Oct 19, 2005 1:38 am
Location: Fort Wayne, Indiana

Re: SES II

Postby Kerry Addington » Fri May 28, 2010 11:57 am

Good to know, Pete.
Thanks and looking forward to seeing Ohio!
Kerry Addington
Registered User
 
Posts: 87
Joined: Fri Nov 11, 2005 1:47 pm
Location: Indiana


Return to R/C Modeler

Who is online

Users browsing this forum: Yahoo [Bot]