aquadeep wrote:Here is some more mods I have done.
The 2 ribs are assembled with 2 stainless steel shafts and nuts and lock washers supplied.
The inner diamiter is 110mm as are the locking rings.
Since I won't be useing the Arkmodels inner caseing I had to make the inner diamiter smaller by some 4 mm to fit my caseing.
This was done with a section of shedule 20 4 inch irragation pipe.
I still needed 2 mm more and that was from the socket side of the same pipe ,2 sections cut and glued in place while the tube is inserted to insure alighnment.
The tube is not glued in.
Now the caseing will slide in and fits with no slop at all.
The 2 rings are glued onto the special ribbs and at the proper location in there rottation and set asside checking that there not missalighned.
The instructions are in Chinese but the pictures are very good.
Users browsing this forum: Bing [Bot]