In order to hook it up my plan was to drill a hole in the end cap and use a servo extention wire to run from the front of the sub and go in the back plate of the wtc and hook it up. There was some controversy as to how to hook it up. My plan was to install the line splitter after the apc and before the mixer for the X-tail that way I could control all planes from one stick and have them all controlled by the apc. Everything that I had read on this forum told me that it wouldnt work. Well I just had to try it. More on that later. Now some more pictures.
drilling hole. Not for the faint of heart
exitting servo control line to plug into bow mounted servo
bellows seals purchased on ebay to add additional sealing to pushrod seals
additional foam installed at waterline to help make up for the added weight of the servo and hardware
There are OLD pilots and there are BOLD pilots but there are very few OLD BOLD pilots. MAG