I have recieved all the parts that I need, and I thought I would share some of them with you.
Here you can see the precision ball bearings that I will use to suspend the main shaft and the 1/4" brass tube that will motivate the propellors. The 3/16" bearings will support the short shaft that will apply the drive motion to the gear rotating the1/4' tube. Also you can see the thrust bearings that will be used to reduce friction.
Two new speed 400 motors
Installed in their motor mounts
In this closeup you can see the motor connection tab and on it the lead from the supression capacitor mounted inside.
There are OLD pilots and there are BOLD pilots but there are very few OLD BOLD pilots. MAG