Jeff, Thanks for your message. The picture was interesting. Thanks, but I'm going to keep looking (and asking).JWLaRue wrote:You could make your own waterproof switch by using a simple sliding switch from Radio Shack (or equivalent), connect a brass rod to it and then feed the rod through a standard BHS seal. The rod is exposed to the outside...you push and pull it to operate the switch while the BHS seal keeps out the water.
I first used this on my OTW Type VIIC model as seen below....though in this case the switch is in it's own dedicated 'dive module':
Users browsing this forum: Bing [Bot]