Banner Ad 1

Engel APC - location

R/C Submarine modelers

Postby jlemons » Tue Apr 15, 2003 7:02 am

Greeting all

Well with a little help I'm down to the last few items on my Typhoon. With any luck the sea trials will be in about 2 or 3 weeks. The last item to locate is my Engel APC.
I now how to mount it, but where? ??? I would assume that it would go close to center line and midship. A'm I corret in this assumption?




Edited By jlemons on 1050404810
James Lemons
Fort Worth Texas
You are correct Captian, I see them. On our right as well as our left. Sensors indicate them to be.....................gray hair.
User avatar
jlemons
Registered User
 
Posts: 11
Joined: Mon Feb 24, 2003 9:59 am
Location: Fort Worth, Texas

Postby Skip Asay » Tue Apr 15, 2003 9:53 am

Automatic leveling controls such as the SubTech APC-3 or the Engel/Brueggen APC are angle sensing devices so their location within the boat is not critical. If any part of the boat angles either up or down, the rest of the boat has the same amount of angle, right?

Skip Asay/SubTech
The U.S. of A - Land of the Free BECAUSE of the Brave
Skip Asay
Registered User
 
Posts: 255
Joined: Fri Feb 21, 2003 11:04 pm
Location: Sanford, NC

Postby raalst » Wed Apr 16, 2003 4:16 pm

If the apc is a device with a pressure sensor
then the pressure sensor is advised to be mounted
so that turbulence in the water near the
pressure sensor tube is minimal.
so preferably in a free-flooding space.

the rest is indeed plain old angle detection and
unless you are building flexible subs, it does not matter.

Regards,
Ronald
Regards,

Ronald van Aalst

--------------------------------------------
Just here to Learn
User avatar
raalst
SubCommittee Member
 
Posts: 1319
Joined: Wed Feb 26, 2003 8:46 am
Location: netherlands, the hague


Return to R/C Modeler

Who is online

Users browsing this forum: Ober Freak