Banner Ad 1

Epoxy Removal?

Post your favorite modeling 'tips' and 'tricks'

Epoxy Removal?

Postby Ramius-II » Tue Sep 08, 2009 5:48 pm

I just finished inserting some parts to some holes in the fiberglass hull. Apparently the tape used did not stick as well as I expected and now there is a think layer of the T-88 epoxy where I do not wish it to be. Sanding the excess is one option and I would like to avoid this as I have a fear of accidently removing the scribe lines. Is there any other way to remove the excess?

Thanks, Ed
Just one more wire!
SC# 2268
WB6NSN
User avatar
Ramius-II
SubCommittee Member
 
Posts: 394
Joined: Tue Apr 01, 2003 6:35 pm
Location: Lomita California

Postby Pirate » Tue Sep 08, 2009 8:09 pm

If it was quick cure epoxy, usually 5-minute epoxy, you can try soaking it in water. That quick-set stuff is not water proof and may loosen and be able to be popped off, but it may take a while of soaking—days. Otherwise, break out the Dremel.

Pete
HOLD FAST
User avatar
Pirate
SubCommittee Member
 
Posts: 795
Joined: Wed Oct 19, 2005 1:38 am
Location: Fort Wayne, Indiana

Re: Epoxy Removal?

Postby xxl » Tue Dec 15, 2009 9:17 pm

dermel o yeah
Captain Ramius: You're afraid of our fleet. Well, you should be. Personally, I'd give us one chance in three. More tea anyone?

Stihl 026 066

Engel lafayette
User avatar
xxl
Registered User
 
Posts: 80
Joined: Thu Jul 03, 2008 5:38 pm
Location: earth

Re: Epoxy Removal?

Postby RickNelson » Wed Dec 16, 2009 6:58 pm

I recently purchased an "Epoxy Remover" ($14 per pint) by PTI Process Chemicals through McMaster-Carr. http://www.mcmaster.com/#catalog/115/3340/=4ymvoa

I have not tried it yet but it might do the trick. The instructions read: "First test epoxy remover for suitability on a small area. If suitable immerse or coat parts thoroughly. Remove epoxy when softened. Softening time will vary with the epoxy type and thickness."

Good Luck and please let me know how it works if you try it.
Rick Nelson

Qualified in Submarines 1965
SCM #2583

"D..n the pressure, Six-Zero feet!"
"Most men would rather die than think, Most of them do!" - Bertrand Russell
"Boomers hide with Pride"
User avatar
RickNelson
Registered User
 
Posts: 188
Joined: Sun Dec 03, 2006 2:57 pm
Location: Palm Harbor, Florida


Return to Modeling Tips and Tricks

Who is online

Users browsing this forum: No registered users