Banner Ad 1

Revell Type VII  upgrades

Static Submarine modelers unite!

Postby Mkeatingss » Wed Jan 26, 2005 7:41 pm

I received parts from Steve Nutall, today. Check out his site at << >>
The parts for the 1:72 boat are a must have. Absolutly beautiful work.
The 'scopes and gun barrels for the 1:125 are worth having, even if you don't plan to build the model. But you'll need a pretty good magnifier to really appreciate them.

As far as the cost, both sets are well worth the price.
I don't suffer from ulcers, I'm a carrier.
User avatar
Registered User
Posts: 247
Joined: Sun Nov 30, 2003 4:03 pm
Location: Chandler,AZ

Postby Steve Nuttall » Sat Feb 19, 2005 4:29 pm

Hi Mike

I just popped in to say Hello to the guys and to update my url to the new website
this is the new sub page
this is the main page; i also offer ship replacement barrels and even some AC barrels
Steve Nuttall
Registered User
Posts: 140
Joined: Sat Feb 19, 2005 4:24 pm
Location: Sarnia Ontario Canada

Postby sam reichart » Thu Feb 24, 2005 2:10 pm

I'm just about complete with the construction phase of the Type VII, and I've used the Yankee Modelworks interior, the ModelBrass deck and other photoetch, and Steve's barrels for the 20 and 88, the shafts for the props, and the brass scopes.

to be completed: attaching the decks permanently, the railings on the deck, and the rigging. then on to paint!!!

Each one of these add ons really helps take this model to the next level. Awesome stuff!
Great work by all the vendors for the add ons they offer.

I'm building this boat as U-83, cause I just love those camo paint jobs!
what were once vices are now habits
User avatar
sam reichart
Registered User
Posts: 714
Joined: Fri Feb 21, 2003 9:20 am
Location: Mechanicsville, VA

Postby Steve Nuttall » Thu Feb 24, 2005 2:39 pm

I know most UBoat guys also love the S100 (whats not to love but the guns)

The the conversion
I forgot to take a shot with the old 37mm while it was still attached

But here is the new; the old and the breech
drilled by hand; nothing fancy here; just drilled #58 in a pin vise (the peg is 1mm)
Tiny drop of crazy glue teased down the hole; pop it's in
Brass Barrel with the mount; stunning difference
It is of course taper drilled
Note; the Bow gun is a different barrel; same basic layout but the breech end is machined slightly modified to the midship 2cm "Zwilling" Flak

Price will be the whole set of 3 20mm flak barrels which I posted before and the 37mm; total with shipping $25.50usd

also these gunscould be pressed into service on the WEM line
Steve Nuttall
Registered User
Posts: 140
Joined: Sat Feb 19, 2005 4:24 pm
Location: Sarnia Ontario Canada

Return to Static Modeler

Who is online

Users browsing this forum: No registered users