Banner Ad 1

U-Boat Conning Tower Stripes

Place for general submarine conversation

Postby 83-1046097211 » Wed Feb 26, 2003 12:00 am

Hi,

I have seen some B&W photos of several WWII Type XXIIIs with either white or yellow stripes on the conning tower. Some of the boats had only a horizontal stripe, and some had both a horizontal and a vertical stripe.

What color were these stripes, and what were they used for? Recognition? I'm trying to decide if I want them on my boat when it is done.

Thanks for the help.
83-1046097211
 

Postby Dolphin » Wed Feb 26, 2003 1:33 am

Hello Steve,

The stripes are yellow, and are about the exact same tone and tint as the yellow
clickable smiles seen on the new board here. These where used for recognition to
identify the submarine as being in work up training. I have seen these on models
representing Type XVIIA & XVIIB, XXI, XXIII boats operating in the Baltic
training areas. Many modelers of German submarines of the types mentioned
above have found them useful also for better visibility when operating their model in pond
water without digressing from scale appearance. These German yellow stripes
would not be worn while conducting operations against enemy forces.

The US Navy used to paint the boat's contract hull number on the sail if the boat
was in port and/or conducting training or of a new skipper I was once told.
Operationally though, the name and hull numbers on US subs would always be
painted out without exception. Today, plastic sail numbers on the sail with magnets
attached are used in port so it is easier for new officers and crew to report duty to
the right address. No need to paint then, just pull off and attach again at the next
port of call.

Regards,

Steve Reichmuth
[I]
Dolphin
 


Return to General

Who is online

Users browsing this forum: Tommydeen