Banner Ad 1

waterproofing wiring from the WTC ?

Place for general submarine conversation

waterproofing wiring from the WTC ?

Postby flying jeep » Wed Mar 09, 2011 7:05 pm

I was wondering if you have a WTC with the ballast tank in the center, and you need to run wire from one side of the ballast tank to the other, do you just seal around the wires with epoxy or silicone sealant? In my first posting, you can see what I'm up against. I need to rework the size of my oversized WTC and make a ballast tank in the center. I'll make the fore planes direct control and the aft planes for a leveler. So I'll need to run servo and power leads from one end to the other. Any ideas?

Thanks,
Jay
flying jeep
Registered User
 
Posts: 44
Joined: Wed Feb 02, 2011 1:43 pm
Location: Brownsburg, IN

Re: waterproofing wiring from the WTC ?

Postby Bill Rogers » Wed Mar 09, 2011 7:45 pm

Some cylinders have a brass tube running through them as a conduit for the wires. The conduit must be sealed at each end of course.
Bill Rogers
Registered User
 
Posts: 93
Joined: Sat Sep 13, 2003 7:58 pm
Location: San Ramon, CA


Return to General

Who is online

Users browsing this forum: No registered users